Experts Choice Panel Scriber
Other products to consider: (11)
In Stock (Ships in 1-3 business days)List price: $10.99You pay: $7.99(All prices in U.S. Dollars)Manufacturer: Bare Metal FoilStock Number: BMF 3View all products of type "Scribe"
The Bare-Metal Scriber is a tool model-builders would have almost KILLED for back in the 1960s. This simple looking tool is so easy to use. I can't imagine anyone having trouble mastering it in just a few minutes. Like any tool, you do have to treat it with respect. Used with care and finesse, though, it creates panel lines so quickly and easily, it becomes as indispensable a tool as the #11 X-acto blade in a #1 handle. And it truly is not a difficult tool to master, just work slowly and with care and you should have no trouble right away.
When using the Bare-Metal Scriber it is important to keep the tool perpendicular to the panel you are scribing. If you are off, it will gouge the sides of the body and make the gap look excessively wide. This is why you must work slowly and be aware of how you are holding the tool. This is especially important when using the Bare-Metal Scriber to open doors or trunk. If you are not working the Scriber perpendicular to the surface, you easily could have a wider gap between the opening part and the body. If this happens, there is no need to discard the body and buy another kit (although you won't find a manufacturer who would say that is ever a bad idea!) you just fill the gap with sheet plastic. This was often necessary when using older methods of cutting out doors and trunks. If the gap is too wide, glue .010" thick plastic strips to the sides of the doors or trunk lid. Let this dry fully. These strips must be a little higher than the part, then once the glue has fully dried, cut and/or file the plastic down to the thickness of the opening part. If curves are involved, this will be a very tricky step, but necessary if the gap is excessive. Once the filler piece is sized to the part, test this part in the opening on the body. The plastic filler will likely be too thick, making it necessary to file or sand the plastic down to get a good fit in the opening for the piece. Do remember to make the gap wide enough.